Would like a bar narrower than OEM
On my 900 Classic LT. But I can't much reduce the reach back.
I might just cut off 1.5" from each end of the OEM bar.
Suggestions?
I might just cut off 1.5" from each end of the OEM bar.
Suggestions?
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Kawasaki Vulcan Forum
A forum community dedicated to Kawasaki Vulcan motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, Vulcan 1500, Vulcan 2000, Vulcan 500, Vulcan 1600, Vulcan 900 and all other Vulcan motorcycles.
Full Forum Listing
Explore Our Forums
Recommended Communities
