Kawasaki Vulcan Forum banner

21 - 22 of 22 Posts

·
Registered
Joined
·
84 Posts
schlappy95 is correct. I had to install my Wolo Bad Boy using 14 gauge wiring, a relay, and also I used direct wiring to the relay from the battery and incorporated a fuse into the wiring, and then another 14 gauge gauge wire from the relay to the horn itself. The relay is activated by the stock horn wiring and switch.

Why did the original owner remove the relay when he sold you the V2k?
He removed whatever horn he had and put a stock horn back in. So I used the relay he had wired up. But I did notice that a portion of the wring was not good and replaced it. I need to go Bach and make sure it is not spliced someplace up to the battery.

Sent from my SM-G955U using Tapatalk
 

·
Registered
Joined
·
1,273 Posts
Kinda in a similar situation. I just bought a pair of Wolo Loud-One horns. (one low, one high tone)
Now I need to figure out where to mount them.



[EDIT]: I think I figured out where they will be mounted. I'll post pictures once I have them mounted, as well as a before/after vid of the horn sound.
I have these on my 900. I''ll be looking into a mount location for them on the Vaquero this weekend.
 
21 - 22 of 22 Posts
Top