Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Looking for someone's help...perhaps they can just snap a picture with their phone....

I am replacing a PCV with a Cobra FI2000R. I've taken off the PCV and installed the Cobra, but when I went to start the bike it was just "cranking" with the engine not "kicking over." I'm reasonably certain the issues is with the stock ignition coil wiring. The PCV was connected to them, and when I unplugged the PCV, I didn't keep track of which color wires went to which pin. Needless to say, I realize this was totally bonehead, but I can't find a post/diagram/picture anywhere and I don't want to take it to the dealer and give them $200 for plugging in just a few wires.

Would someone be kind enough to remove their cosmetic cover on the left side of the engine and snap me a picture? I just need to know what wire goes on which pin from side to side. I would be very appreciative!
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Thank you very much! Have a good weekend!
 
1 - 3 of 3 Posts
Top