Kawasaki Vulcan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Let me preface this with I'm good enough with a wrench to do a motor swap it just don't know specifics and details. I know enough about a car to swap rims when it comes to width diameter and bolt patterns but I'm kind of lost when it comes to motorcycles. With the rotor mounting to the wheel I'm spacing inside the forks I just feel a little overwhelmed I would love some guidance.

I'm looking for a wheel compatibility chart for all years the Vulcan 900.

My ideal solution would be to put a front and back wheel off the blacked out custom 900.

I need to find out if it'll fit my 2006 Vulcan 900 classic.

Any assistance is appreciated have a wonderful holidays.
 

·
Registered
Joined
·
67 Posts
Everything depends on axle size. If the axles are the same size, then everything else may just fall into place. I did an axle and tire size change to my Concours. I used a front rim from a 2001 ZR-7 as the axle had the same diameter with a 17 inch tire as the 2004 Concours had with the 18 inch. The only thing I needed to do was swap the front rotors from the 2004 Concours to the ZR-7 wheel. Do a search for Kawasaki Vulcan axle sizes. They maybe all the same...
 
1 - 2 of 2 Posts
Top