Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
So little bit of an interesting problem, I took off the rear turn signals of my Kawasaki Vulcan 500 to give them a Polish and clean as they were really dirty I also just wanted to have the experience in case I ever wanted to move or replace them. I looked up all the wiring previous to doing it and knew where each wire needed to go when assembled it back together. however when I put it back together and I turn the ignition but do not actually start the bike the two front signals turn on and the back to do not, I don't mean they flash I mean they just stay a solid orange without the bike being started. should the back to turn signals light up like the two front ones or should they stay dark unlit until I activate them?
 
1 - 3 of 3 Posts
Top