Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter #1
I had to take the fork tubes off my 2009 Custom to slip in some headlight brackets... Does anyone know the torque specs for the axle nut, as well as the 6mm and 8mm hex screws on the triple tree?
 

·
Registered
Joined
·
22 Posts
I had to take the fork tubes off my 2009 Custom to slip in some headlight brackets... Does anyone know the torque specs for the axle nut, as well as the 6mm and 8mm hex screws on the triple tree?
The axle nut is 79.7 ft·lb and for the 6 and 8 mm hex screws is 52 ∼ 69 in·lb and 10.0 ∼ 13.5 hope it helps u.

Best regards Mike
 

·
Registered
Joined
·
74 Posts
Discussion Starter #4
Since I managed to mangle the bottom half of the triple tree, I need to replace it too... Does anyone know the torque setting for the top nut? I already have a replacement lower, I want to tackle this project this weekend and RIDE, darn it!
 
1 - 4 of 4 Posts
Top