Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter #1
I was just about to install my new Thunder Tornado on my V2K and realized there is no place for the air temperature sensor. Unless I am missing something or one of you guys have any ideas. Can't wait for what Thunder Mfg has to say about this. I sent them an email. It will be interesting how long it will take them to reply back to me and tell me I don't know what I am doing and I should have it installed by someone qualified...

Pics attached...




 

·
Registered
Joined
·
110 Posts
Discussion Starter #2
Here is the reply from Thunder MFG..... "On the VN2000 the sensor gets placed on top of the wiring harness that lays across the top of the throttle body and is zip tied in place."
 

·
wocka, wocka, wocka
Joined
·
5,618 Posts
Stuffin it or wire tie the bugger down.

bh, yup thats what I do with it. I stuffed it into the top of my bell housing as there was minimal room for it to sit snuggly and not walk off. Ya dont want to be buggerin up your 'spensive acrutrament with no unsightly wires n pokie things. 'sides it just is measurin the ambient temp for your FI module. out, ponch
 
1 - 3 of 3 Posts
Top