Kawasaki Vulcan Forum banner

Sheeez he makes that look easy

1544 Views 8 Replies 6 Participants Last post by  smedlin
Be nice to be this good at tight turning the V2K, I'm getting there but no where as smooth, still manage to make a mess of it at times, haha

Mind you, I'm doing this two up, so has a factor on it too.


https://www.youtube.com/watch?v=loBejwHEbqE
1 - 9 of 9 Posts
Very Nice indeed.... looking at the way he rides and the Helmet he is wearing I would say he rides for a living, LE Motor. just my opinion.
If you listen closely you can hear him work the clutch alot. and I would guess trail braking too.
FYI, the V2K is "Robotic's".

He's a member here.

Here is a pic of his bike.. same one in that video.

See less See more
FYI, the V2K is "Robotic's".

He's a member here.

Here is a pic of his bike.. same one in that video.

Huh, small world eh, nice lookin sled and sounds good with those pipes. Are they are the same as your set up Smed?
Watched the video and was impressed. I can do a figure-8 but no where near as tight (need the whole road). Look closely, he's dragging his boards all the way through both left and right turns. Can't go no tighter. Sport bike it aint!
He's at the absolute limit to what the bike allows. I intend to be at that level in the spring with practice.

What I'm trying to say is that if I post I'm going riding and then nothing else for a few days, come find me and pick the bike up off me.
What I'm trying to say is that if I post I'm going riding and then nothing else for a few days, come find me and pick the bike up off me.
LOL, nice one:D
RedDog
........
Heaven forbid, but before you leave make sure we know where to look, it will shorten your wait!! :p :p
I showed that video to my wife...

She was like.. "You can't do that. You can't turn it that tight, it takes you longer."

I was like.. "Your darn tooting right. I can't do that.. not even going to try."
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top