Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1 (Edited)
Hi,

I removed my rear wheel to get the tire changed out. I had the new tire mounted and proceded to re mount the tire. After I installed the wheel I had a washer left over on the floor. Needless to say I am having a time trying to figure out where this washer should be installed. I have included a drawing can I get some help on this?? The question is where does the washer go up against the shaft or the bearing, when I install it against the bearing the wheel does not fit in the frame. 1999 Kawasaki Vulcan EN500 LTD

Thanks ahead of time.
 

Attachments

1 - 1 of 1 Posts
Top