Kawasaki Vulcan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Anyone know anything about the CobraFi2000R, the three pod device? I have one, made mods....thunder mfg tornado(with gasket), cobra scalloped slips, wrapped exhaust, plugged AIS, I have played with tuner, seems to run fine, but still get popping under @2000rpm, regardless of what gear it seems. I am going to seal pipes where slips meet, and put in new header gaskets(I remember when I removed to wrap, there were no gaskets),and I run 89 octane. if anyone has this device what are your settings? If not any help appreciated.
Thanks
 

·
Registered
Joined
·
851 Posts
I had one my 900 and thought it was a pain in the butt to get setup just right. I'm sure the settings are a little different from my 900 to the 1700 but if I remember my settings were about 3.5-5-1, When I set the middle pod up to 5 it seemed to get rid of 99% of all my popping. Your best bet would have been to spend the extra $100-$150 and got a PCV and had it dynod on a machine for your best results. Good luck!
 
1 - 2 of 2 Posts
Top