Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
782 Posts
You could just take the pegs to a local steel fabrication shop and have them make you a stand-off block from some square bar stock that is say 50-75mm long with the proper holes drilled for the bolts. Then just buy bolts that are long enough to go through the block and the peg bracket. If they make the stand-off block out of stainless, just polish it up with some sand paper and steel wool. If it is carbon steel, sand it and paint it black with some enamel spray paint.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
i have a look at kuryakyn shop in London, but they quoted 250 pounds for this :(
i need to find cheaper solution...
 
1 - 4 of 4 Posts
Top