Kawasaki Vulcan Forum banner

New to Vulcans

1075 Views 5 Replies 4 Participants Last post by  vnnikolouzo
I recently got my bobber project up and running and having a really fun time riding it. I usually ride a sport bike so I was pleasantly surprised as to how fun the little VN700 is to ride.

I did the work myself except welding the titanium, that I am not equipped to do in my garage. It isn't quite finished but I ride when I can.



See less See more
2
1 - 6 of 6 Posts
I recently got my bobber project up and running and having a really fun time riding it. I usually ride a sport bike so I was pleasantly surprised as to how fun the little VN700 is to ride.

I did the work myself except welding the titanium, that I am not equipped to do in my garage. It isn't quite finished but I ride when I can.



looks good,what filter set up u use?oem carbs?
I built a common manifold and run a 40mm Keihin from an 883 on it. Currently it has a 48 slow jet and stock main with 3 shims under the needle, I may go down to a 46 to see if I can lean it out a little. I runs good, just a little rich. The filter is an ebay special for a non cv carb that I opened up and re drilled for the cv.
I built a common manifold and run a 40mm Keihin from an 883 on it. Currently it has a 48 slow jet and stock main with 3 shims under the needle, I may go down to a 46 to see if I can lean it out a little. I runs good, just a little rich. The filter is an ebay special for a non cv carb that I opened up and re drilled for the cv.
i bet u got a few horses more with that carb,stock bike does 13.7 in 1/4, u should be able to see 13, the bike should be lighter than stock too
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top