Kawasaki Vulcan Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter #3
Still trying them out. :). So far better than the 2" ones I had. With the two inch ones I had a slight angle on my back. It would pinch just right and hurt sometimes. Feels better with the taller risers.
 

·
Registered
Joined
·
90 Posts
Discussion Starter #5
No turned out of 316 stainless on my lathe and polished. They are 3-1/2. Chose that length because 6" were the longest 3/8 bolts I had on hand.
 

·
wocka, wocka, wocka
Joined
·
5,618 Posts
No turned out of 316 stainless on my lathe and polished. They are 3-1/2. Chose that length because 6" were the longest 3/8 bolts I had on hand.
43,, wuld be good to see pix of finish on the bike w/riser n barz.. details are always helpful. thx, poncho
 
1 - 7 of 7 Posts
Top