Kawasaki Vulcan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
445 Posts
Discussion Starter #1
I'm in the process of swapping out my rear turnsignals for Kuryakyn dual circuit run/turn set-up
that has three ( 3 ) wires compared to the two ( 2 ) wire OEM set-up .

Would I hook up the run wire to the RED wire going into the taillight ?

Also is it a safe bet that if I wanted to run a new license plate light
I can cut the exsisting 2 lines and re-direct them to the new two wires.
 

Attachments

·
Registered
Joined
·
136 Posts
I'm in the process of swapping out my rear turnsignals for Kuryakyn dual circuit run/turn set-up
that has three ( 3 ) wires compared to the two ( 2 ) wire OEM set-up .

Would I hook up the run wire to the RED wire going into the taillight ?

Also is it a safe bet that if I wanted to run a new license plate light
I can cut the exsisting 2 lines and re-direct them to the new two wires.
yes.......(bk/y is ground)


yes
 

·
Registered
Joined
·
445 Posts
Discussion Starter #5
Well... all went well. Not perfect. I had to dismantle everything once before I got it right.
I did it all in one shot.
Plate relocator - Barons turnsignal bracket - Kuryakan duel circuit turnsignals - led license plate holder.

Turned the key and all worked with no sparks or fire.:)
Knocked another project off the list.

Thanks to RRKR for confirming the wire set-up.
 

Attachments

1 - 5 of 5 Posts
Top