Kawasaki Vulcan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello everyone, I have a 1990 vulcan 1500 I rode it to work with no problems while coming home from work when stopped at lights with the lever pulled in all the way, my bike wanted to creep forward which ended up stalling. I got it home bleed the master cylinder 10 times and still does it was wondering if I needed to bleed the slave or is it another issue all together
 

·
Registered
Joined
·
30 Posts
I've a 91 Vulcan 88 1500, 27,400 miles, jus replaced worn out clutch spring myself.

Possibly that clutch not opening enough to disengage ?.
Bleed slave cylinder, never hurts.
Slave is rebuildable as well.
An it's simple compared to gettn to,,,,, an eye balling clutch.
If u havent, invest in good service manual, check u tube,
I'm by far no expert a 61 yo shadetree guy,
Sooner or later ull see responses from the guys an gals. This site's saved me $$$$$,. Couldn't afford
If not for sites like this..
Captain John Montgomery AL
 
1 - 2 of 2 Posts
Top