Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
hey folks I just put a set of Chuckster risers on the voyager and want to move the front brake hose behind the Tripple tree, thought it would be easy to just disconnect it from the master cylinder, re-attatch and bleed,,,,so the question is,,,,is it that easy or are there any tricks to get it bled with the linked brakes and ABS?
 

·
Registered
Joined
·
3,881 Posts
Would suggest replacing the crush washers on the banjo fitting at the cylinder. I replaced the fluid on my 12 Voyager ABS a while back and used a vaccum pump to bleed them, $25 from Harbor Freight. You should be able to bleed normally if you dont have the pump, it just makes it easier.


Sent from Motorcycle.com Free App
 

·
Premium Member
Joined
·
1,186 Posts
When I installed my risers, I was able to move the line out of the bracket in from of the triple trees and it had plenty of room. The line stayed on the front of the trees.
 
1 - 3 of 3 Posts
Top