Kawasaki Vulcan Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Im waiting for an admin to tell me its ok to post this. I found it on another forum and it has pictures and plans on a 2 to 3 inch drop. Done very professional. and gives all the measurments. Its like and 1/8th inch makes it lower 1 inch.
 

·
Registered
Joined
·
33 Posts
Discussion Starter #4

·
Registered
Joined
·
742 Posts
i like the idea of 'holes' rather than slots like the britt has... it seems like an easy enough mod, wish i saw this before!
 

·
Registered
Joined
·
33 Posts
Discussion Starter #6
I'm glad I didnt buy one. I'm doing this mod but instead of welding up the bolt hole I'm just going to cut behind it then figure out how much I need to get those measurements put the two pieces together to drill them and weld them on. Looks like you wouldn't even have to take it of. Just take the lower two bolts out and pull it down but might be a little easier to take it off.

These places should give us the option to send ours in to have this done for a lot less money.
 
1 - 6 of 6 Posts
Top