Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
814 Posts
Discussion Starter #1 (Edited)
The bolts holding the handlebar holders use 10mm bolts. The risers I am purchasing use 1/2" bolts. (1500 Drifter)

What to do?

Drill out the triple tree holes?

Or are double ended studs available with larger diameter standard thread on one end and smaller diameter metric on the other? Or would the studs need to be machined?

I'd be reluctant reaming out the holes and don't want to go that route.
 

·
Registered
Joined
·
814 Posts
Discussion Starter #3
Thank you Phillip!

I had spoken to American Fasteners and was about to pay big $ (TBD) for a pair of studs - waiting on the risers to get details. I see Scootworks has the right pair.:good:
 
1 - 3 of 3 Posts
Top