Kawasaki Vulcan Forum banner

1 - 5 of 5 Posts

·
BOTM Winner, February 2014
Joined
·
95 Posts
Discussion Starter #1
G'day all, seen a few bikes with the wiring for the indicators, horn etc, running through the handlebars then out at the bottom near the tripple trees. Very clean look.

Is it a hard procedure to accomplish?

Cheers.
 

·
Registered
Joined
·
1,131 Posts
I believe you can do this with a set of HD handlebars. Some of their (upper end) models have the wires running inside the bars, so I imagine you can get a set of their bars and run the wires on your bike through the bars. I don't think the HD bars are any more expensive than any other handlebars.
 

·
BOTM Winner, February 2014
Joined
·
95 Posts
Discussion Starter #5
just check Burleigh bars in the industrial estate off Reedy Creek Rd in Burleigh.

2/16 Ern Harley Drive
Burleigh Heads
Gold Coast, Australia 4220

http://www.burleighbars.com.au/customhandlebars_gallery.php

Cheers
Thanks Cruiserone, will give them a call on Monday. Was actually thinking about going with the Climax Hand Controls from www.customcyclecontrols.com/, but at $3k+ think it's a bit over an over kill for the 900.

The other idea was just to drill the holes in my stock bars, perhaps not the best, but easy enough.

BTW, hooked up with the Gold Coast Cruiser Club, having some good rides lately :)

Cheers.
 
1 - 5 of 5 Posts
Top