Kawasaki Vulcan Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I installed a set of screaming eagle cvo 2015s on mine. Was not hard. Cut off the left side one at the clamp stop. Had to fab a short piece for the right side. The results was very shocking. They sound very good. They increased the low end torque. I later took the fiberglass packing out and left the metal baffles. Sounds even better. I later found out V&H MAKES those pipes for HD. Only had the drill a hole for the ox sensor. I used a piece of flat bar. For a adapter.

Sent from my SM-G930P using Tapatalk
 

·
Registered
Joined
·
580 Posts
I installed a set of screaming eagle cvo 2015s on mine. Was not hard. Cut off the left side one at the clamp stop. Had to fab a short piece for the right side. The results was very shocking. They sound very good. They increased the low end torque. I later took the fiberglass packing out and left the metal baffles. Sounds even better. I later found out V&H MAKES those pipes for HD. Only had the drill a hole for the ox sensor. I used a piece of flat bar. For a adapter.

Sent from my SM-G930P using Tapatalk
Can you post some pics and possible a link to a sound clip
 
1 - 2 of 2 Posts
Top