Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I went to adjust my aftermarket handle bars today and they are slipping in the clamps. I have the bolts pretty damn tight but I can still pull them forward and aft in the riser.

These bars are 8 inch z bar and were rock solid before I messed wit them. There is no knurling on the bars. Is there something I can do to lock them in better. I don't think I can get the bolts much tighter without busting them.
 

·
Registered
Joined
·
216 Posts
If it were me, I would start with a layer or two of friction tape you use for plumbing. Use as much or as little as you need, should do the job and be all but invisible. I also use lock-tite on my riser boils.
 
1 - 4 of 4 Posts
Top