Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter #1
When I replaced my stator, a few weeks ago, I had to remove the front pulley to get access to the wires behind the plate, I noticed that the pulley was mounted with the guide lip on the inside of the bike, so I put it back exactly the same way, assuming it was right in the first place.
I also noticed that the pulley would fit with the guide any way, inside or outside...

The other day I was looking at the service manual and noticed that the front pulley was mounted with the guide on the outside :eek:

Is this really important, if it fits either way?

So before changing it (lots of work) I am seeking good advice from you mechanically minded experts.

Thanks
 
1 - 1 of 1 Posts
Top