Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
Does anyone have a wiring diagram showing where to install the flash2pass? Also I was looking at how to get to the headlight and install in the light bucket. If anyone has done this before, I will gladly accept guidance.
 

·
Registered
Joined
·
64 Posts
I installed one on my 1700 classic. Just remove the two Phillips head screws on the headlight bezel and pull the head light out. Then connect the matching colored wires coming from the rear head light plug.
 

·
Registered
Joined
·
18 Posts
Discussion Starter #4
Do you remove the screws at the bottom of the bezel on the batwing to remove that bezel?
 
1 - 4 of 4 Posts
Top