Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
Hello,

I have my new stator, my new pulse coil, my new stator gasket, and permatex right stuff.

My plan is to do the following:
1. put the gasket on by itself held in place by the dowels sticking out of the engine side with no liquid on it.
2. put the stator grommet in first (on the bottom) with its flat side up and put permatex right stuff on all four sides of the stator grommet and goop it over the inside face where the wires penetrate the grommet.
3. put the pulse coil in second (on top) with its flat side down and put permatex on three sides (not the top/gasket side) and goop it over the inside face where the wires penetrate the grommet.
4. let the permatex setup for 90 minutes
5. attach the stator cover to the engine and torque bolts correctly

Does this sound like a good plan? I don't want to do this again. Have I missed anything?

Thanks,
Brent
 
1 - 1 of 1 Posts
Top