Kawasaki Vulcan Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a 2008 Nomad 1600.
I changed the oil, the oil filter and drained the oil through the oil screen. I replaced with new filter, and oil and cleaned the oil screen.
So far things are going well. I emptied my oil catch basin into a plastic bottle for disposal and I found an o ring at the bottom of the catch basin. I measured the inside diameter of the o ring and it is pretty close to 35mm.
I checked my oil filler screen cap, and my oil filler cap and both of these have an o ring on them.I can.t figure out where this o ring should go.
Any ideas?
TIA
Tom
 

·
Registered
Joined
·
360 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Drained oil thru oil screen. No it is not the grommet at the end of the screen. The o ring is larger than the grommet.
Thanks for your reply.
Tom
 

·
Registered
Joined
·
313 Posts
Was the catch can clean when you started?
 

·
Registered
Joined
·
1,163 Posts
it's 92055-1358 O-Ring
 
1 - 6 of 6 Posts
Top