Kawasaki Vulcan Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter #1
While removing my ecu to send into Ivan I broke the locking tab on the ecu connector that clicks and locks onto the ecu body. Is this a big problem and if so how would I go about replacing the connector female end without removing the harness. Any opinions would be appreciated
 

·
Registered
Joined
·
580 Posts
any way to zip tie it? had to do it on an old car iginition.
This may be your best option. The connector is a tight fit and likely wouldn't come loose but no use taking a chance
 

·
Registered
Joined
·
162 Posts
Discussion Starter #4
Thanks to dlars and allbsharp for the reply. I was looking at the connector and realized I could drill a hole in a zip tie and put it over the ecu lock fastener and run it up through the connector where I could lock it into the head of the zip tie. This seems like it would work and if I made a couple of them if I needed to remove the connector I could just snip it and reuse another fabricated zip tie. Much better than trying to glue it or replalce the connector. Thanks for the ideas.
 
1 - 6 of 6 Posts
Top