Kawasaki Vulcan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
how’s it going everyone, I recently put new bars and grips on my vn900 classic. I also decided to go with some nice steal braded lines as well. it’s all on the bike and looking good however I can’t get my clutch right......if I pull the clutch and shift into 1st bike stalls..... I have adjusted this thing 20 times now.......if bike is off and I put it in 1st it won’t roll, pull in the clutch rolls fine.......any thoughts???
 

·
Registered
Joined
·
976 Posts
Anyways, if it dies when you put it in gear regardless of where the clutch lever is, the switch has come unplugged, plug it back in. There's a switch on the kickstand too in that loop, it causes the same problems. Depending on where I'm parking it's usually how I shut the bike off, throwing the kickstand down.
 
1 - 5 of 5 Posts
Top