Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi im customizing a bike using a stock vn2000 frame and rear wheel the engine is a 750 lol yea but what im looking for is a way to convert the rear wheel from pulley to chain, any ideas?

I have the rear sprocket and everything from the 750 honda and it will fit the wheel of the vn2k if i remove the black spacers in the hub and grind them down a little but i have not done it just wondering if there is a better way.
 

·
Registered
Joined
·
1,223 Posts
Why not change the front sprocket to accept a belt? Sure would be a lot easier.

I put a belt kit on my 750 Honda so i know they're out there.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #3
Why not change the front sprocket to accept a belt? Sure would be a lot easier.

I put a belt kit on my 750 Honda so i know they're out there.
oh because the frame is also being stretched a bit too sorry that i didnt include that and im not sure if i can find a belt long enough? where did you get your belt kit?

oh yea and another reason is i dont have the pulley any longer .
 

·
Registered
Joined
·
1,223 Posts
I got the kit from Scootworks. Not sure if you could get a longer belt for it.

Please note: Although i'm not finding fault with Scootworks products, i would strongly advise against ordering items directly from them. Purchase your Scootworks items through Mean Cycles.
 
1 - 4 of 4 Posts
Top