Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter #1
I have installed the Scootworks pulley and still working to get belt right. Thought I have it just to outside but enough I could see pulley between belt and edge.

I have the front cover off so I can see belt on the front pulley. Belt was tracking dead center on front pulley maybe little inside then all of a sudden its far outside. Then I look down and its near center again.

What causes belt to move like that...too loose?

Help I'm at my wits end. It rides enough outside I get a vibration (or its in my head) but never noticed any actual squeeking.

Thanks Frank
 
1 - 1 of 1 Posts
Top