Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
Looking to get a new set of Z bars. My question is should the bars be dimpled, drilled or what not. I never really understood the different in them.

Also, if i get a 2'' riser with 10'' bars, does that equal 12'' of height or is it still 10?

I know it sounds like a stupid question, but just wondering.
 

·
Registered
Joined
·
236 Posts
it will make a 12" height, the dimple is usually for harley's but it won't interfere with your application, if you have it drilled, then you can run the wires on the inside for a cleaner look
 

·
Registered
Joined
·
1,432 Posts
I got all excited when I read the thread title. Turns out it's not what I was hoping. :p
 
1 - 4 of 4 Posts
Top