Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I took my time installing this tac . I pulled the tank and ran the wiring down the same path as the harness .I solder the connections and isolated the signal wire as far away from any hi power wire I could (sparkplug wire ,coils) and I still get needle bounce. it jumps a lot at 3 grand . I heard that I can install a resistor in the signal wire and it will smooth out. has anybody tried that
 
1 - 1 of 1 Posts
Top