Kawasaki Vulcan Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
234 Posts
Discussion Starter #1
Hi there!
I'm stuck with a carburetor cleaning on my VN800A. That's because of that old bastard Keihin G200 AKGM carburetor :disapointed:
The Air Cut Off Valve is totally dead and leaky. The problem is that I cannot find any info about this model of carb. No parts, no even part numbers. Seems like the Valve is very similar to other carb models, but I have not enough info to adapt something. Has anybody any information how could I substitute this little rubber thing? Any info on G200 somewhere?
Thank You!
 

·
Registered
Joined
·
234 Posts
Discussion Starter #2 (Edited)
So, if someone needs this, I found out that the accelerator pump valve is actually pretty same as an Air Cut Off Valve on HONDA CB650Z (79-82). Just need to cut off the knob.
And the actual Air Cut Off Valve on a Keihin G200 is pretty the same on PD24J China carburetor.

Good luck!
 

·
Registered
Joined
·
234 Posts
Discussion Starter #3
Yee! :jump: Finally replaced my Air Cut Off Valve! No more backfire!
It's identical to a standard CVK-36.
Replaced it with ACV-401 from Poland.
 
1 - 4 of 4 Posts
Top