Kawasaki Vulcan Forum banner

21 - 22 of 22 Posts

·
Registered
Joined
·
1 Posts
Well, instead of washers, I decided to buy some rubber spacers with M6 (6mm) hole. Bought them in different sizes, with some at 4mm deep, some at 6mm and a couple at 10mm. They arrive on Saturday, so we'll see how that goes. I think it will be much easier to get them in place if they are rubber and single pieces.
Do you have a link where you bought the spacer from? Do you know if I will run in to the same issue on a 2021? Any help you can provide would be greatly appreciated.
 

·
Registered
Joined
·
119 Posts
Discussion Starter · #22 ·
Do you have a link where you bought the spacer from? Do you know if I will run in to the same issue on a 2021? Any help you can provide would be greatly appreciated.
Sure, here you go:


This came with 4x15mm spacers, 4x10mm and 4x5mm. I installed a 10mm on each side and the aim is great now. My guess is that you will have the same issue, since there was not a single change from '20 to '21 other than paint colors.
 
21 - 22 of 22 Posts
Top