Kawasaki Vulcan Forum banner

1 - 3 of 3 Posts

·
Banned
Joined
·
107 Posts
Discussion Starter #1
want to get a side plate can some one plz tell me what size whole i need to fit on the axel trough i read it was about 27 mm is that right
 

·
Registered
Joined
·
782 Posts
I believe the nut takes a 27mm wrench. But the threaded part of the axle is smaller than that. I just crawled on a rather icy garage floor to take a measurement. Due to the shivering, I could only determine that the axle is about 1/2" in diameter. But that may be just a tad tight. I would aim for somewhere between 1/2"-3/4" for the hole in the bracket.
 
1 - 3 of 3 Posts
Top