Kawasaki Vulcan Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
I debaffled my 2006 Vulcan Nomad 1600 using the hole saw and round piece of wood. But how do I debaffle my wife's 2011 Vulcan 900 with the angle flat piece at the end of the exhaust? Help!!!
 

·
Registered
Joined
·
953 Posts
1. Drill out the rivets
2. Peel metal back with pliers/vice grips

3. I cut the baffle off a bit with a saw

4. Stage 1-12" extension with 3/4 " hole saw-Drill out plate near back of baffle
http://www.myspace.com/video/mark/vulcan-900-custom-debaffling-phase-1/57843028
5. Stage 2 (personal favorite) drill 4-8 3/8 inch holes in baffle plate
6. Stage 3- Completely cut around baffle, cut plate off with 3" hole saw, work baffle untill it pops loose

Good luck!
 

·
Registered
Joined
·
7,620 Posts
One of the coolest free mods you can do! Doesn't sound QUITE as nice as aftermarket pipes but it's not nearly as loud either. I'm partial to a full debaffle myself. I started mine up in stages and found that the 'full debaffle' was only marginally louder than the 'stages' but much, much deeper and rumblier.
 
1 - 5 of 5 Posts
Top