Kawasaki Vulcan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
Hi All

so i recently just did a bevel bearing change on my 2005 vulcan 1600a clasic
It all went well with no problems. Then i went for a ride and it was running like a dream. but after about 20 mins i started to hear a rattle.

the rattle happens when the bike is in neutral and if i pull the clutch it goes away.

Is this something to do with the pre-load or gear backlash?

Any help would be much appreciated

Thanks Andy
 
1 - 1 of 1 Posts
Top