1990 vlucan 750 engine installation

Welcome to the forums! I suggest you ask your question in either the general or 750 forums where you will get more views. Not all read the new intro section.

This might help.....

http://jr_allas.tripod.com/documents/gasket_replace.htm

Vulcan engine install

Thanks for the link, i know how to put it together, but I live in a rural area and I can' figure out how to physically lift or jack the engine into the frame/mounts. In the link it said it took him three people to do it, any one know how to do it with only one? (maybe with jacks or some other trick?)

M31 said:

Thanks for the link, i know how to put it together, but I live in a rural area and I can' figure out how to physically lift or jack the engine into the frame/mounts. In the link it said it took him three people to do it, any one know how to do it with only one? (maybe with jacks or some other trick?)

Click to expand...

the back lower mount goes first engine tilted foward,2person job.Easiest time i put engine back was when i striped frame for painting and put frame on engine.The motor was on a big wooden block,frame went into position very easy

Thanks, the hardest part is getting the left side(clutch case) over the left frame at the same time as tilting forward. Also, I have one hose I didn't label. It's the hose from under the fuel tank, below the fuel quantity sensor. Where does the other end go? (CA model)