Kawasaki Vulcan Forum : Vulcan Forums - Search Results
Advanced Search
Showing results 1 to 25 of 200
Search took 0.13 seconds.
Search: Posts Made By: Blaine
Forum: Vulcan 500   08-03-2019, 06:29 AM
Replies: 5
Views: 222
Posted By Blaine
Some had "on" "res" ...

Some had "on" "res" "Pri"
Forum: Vulcan 500   07-28-2019, 06:03 AM
Replies: 33
Views: 988
Posted By Blaine
RTV cures in about a hour when it...

RTV cures in about a hour when it compressed.....No need to wait 24 Hours.
Forum: Vulcan 500   06-26-2019, 06:21 AM
Replies: 26
Views: 991
Posted By Blaine
The rockers tighten & get quieter as miles go...

The rockers tighten & get quieter as miles go on....If you can hear them clicking your fine.
Forum: Vulcan 500   05-29-2019, 06:05 AM
Replies: 12
Views: 1,095
Posted By Blaine
My 454 had 54mm carbs.....I believe they are...

My 454 had 54mm carbs.....I believe they are bigger than the vulcan....Bill is likely right.....I believe I had #36 MJ......Again the 454 had a different size carb.
Forum: Vulcan 500   05-22-2019, 06:51 AM
Replies: 12
Views: 558
Posted By Blaine
Bike will not run properly without the airbox...

Bike will not run properly without the airbox installed.
Forum: Vulcan 500   05-21-2019, 06:39 AM
Replies: 5
Views: 249
Posted By Blaine
Jack front wheel & check for any roughness while...

Jack front wheel & check for any roughness while spinning the wheel...Also could be brake pads.
Forum: Vulcan 500   04-09-2019, 07:04 AM
Replies: 8
Views: 557
Posted By Blaine
Hopefully it just the valves too tight.....Thats...

Hopefully it just the valves too tight.....Thats what it sounds like.
Forum: Vulcan 500   04-06-2019, 07:10 AM
Replies: 5
Views: 401
Posted By Blaine
Like stated (PNF) gearshift lever will not go...

Like stated (PNF) gearshift lever will not go above neutral unless rear wheel is moving.......It's exclusive to Kawasaki.
Forum: Vulcan 500   02-24-2019, 06:35 AM
Replies: 5
Views: 549
Posted By Blaine
If you just want a bulb you want a...

If you just want a bulb you want a...
Forum: Vulcan 500   02-14-2019, 07:01 AM
Replies: 2
Views: 338
Posted By Blaine
You need to adjust the A/F mixture...

You need to adjust the A/F mixture screws.....About 1/2 turn out
Forum: Vulcan 500   02-13-2019, 06:59 AM
Replies: 3
Views: 344
Posted By Blaine
Yep...In that case cap both.

Yep...In that case cap both.
Forum: Vulcan 500   02-11-2019, 07:00 AM
Replies: 3
Views: 344
Posted By Blaine
Just the one on the right...The left goes to...

Just the one on the right...The left goes to vacuum on petcock.
Forum: Vulcan 500   01-27-2019, 06:50 AM
Replies: 14
Views: 865
Posted By Blaine
Small PVC filter from auto store.

Small PVC filter from auto store.
Forum: Vulcan 500   01-17-2019, 06:13 AM
Replies: 5
Views: 674
Posted By Blaine
It not usually the hose but rather the pipe it...

It not usually the hose but rather the pipe it connects too...It has a o-ring on the bottom that sits into the head.....The o rings should be replaced every time the valves are adjusted.
Forum: Vulcan 500   01-16-2019, 06:16 AM
Replies: 5
Views: 674
Posted By Blaine
The O-Ring is 14mm.

The O-Ring is 14mm.
Forum: Vulcan 500   01-14-2019, 06:44 AM
Replies: 6
Views: 923
Posted By Blaine
Usually when bike only runs with choke on you...

Usually when bike only runs with choke on you have a plugged pilot jet curcuit.
Forum: Vulcan 500   01-08-2019, 08:04 AM
Replies: 11
Views: 4,729
Posted By Blaine
Possible I guess.

Possible I guess.
Forum: Vulcan 800   01-08-2019, 07:59 AM
Replies: 14
Views: 1,230
Posted By Blaine
Sounds like sticking floats.

Sounds like sticking floats.
Forum: Vulcan 500   01-07-2019, 06:14 AM
Replies: 11
Views: 4,729
Posted By Blaine
Check your ground.

Check your ground.
Forum: Vulcan 500   12-06-2018, 06:40 AM
Replies: 2
Views: 194
Posted By Blaine
Back two arejust signala......Fronts are signals...

Back two arejust signala......Fronts are signals & running lights....Your good. :)
Forum: Vulcan 500   12-05-2018, 06:46 AM
Replies: 2
Views: 286
Posted By Blaine
No problem on both.... :)

No problem on both.... :)
Forum: Vulcan 500   09-05-2018, 06:30 AM
Replies: 15
Views: 993
Posted By Blaine
Sounds like she may be resting her hand on the...

Sounds like she may be resting her hand on the brake lever causing brakes to drag & over heat.
Forum: Vulcan 500   08-28-2018, 05:53 AM
Replies: 3
Views: 366
Posted By Blaine
.....Its actually a 454 LTD. Kawasaki EN 450...

.....Its actually a 454 LTD.

Kawasaki EN 450 EN 500 454 LTD 500 Vulcan 85 04 - Download service / repair / owner / maintenance manuals, motorcycle tutorials, microfiche...
Forum: Vulcan 500   08-14-2018, 06:15 AM
Replies: 11
Views: 841
Posted By Blaine
Perfect!!!! :)

Perfect!!!! :)
Forum: Vulcan 500   08-07-2018, 06:29 AM
Replies: 11
Views: 841
Posted By Blaine
13v is good for idle should come up to around...

13v is good for idle should come up to around 14.6 when revved up.
Showing results 1 to 25 of 200

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome