oil spray from push rod? - Kawasaki Vulcan Forum : Vulcan Forums
 
LinkBack Thread Tools Display Modes
post #1 of 1 (permalink) Old 09-25-2017, 02:15 PM Thread Starter
Senior Member
 
Join Date: Sep 2009
Posts: 167
oil spray from push rod?

need some help guys. went to the rally last week in NW arkansas. and the ol girl ran great for the most part. but im spraying oil from what looks like the top of the case on the right side on the rear cylinder where the push rods run in. for a while i thought it was oil blowing out of my air filter but i had just cleaned the thing and i had no oil residue on it but the chrome around the shaft that runs up the side of the cylinder and my plastics/ pipes all are coated in oil spray as well as my pants. after i recover a bit from the trip in the next day or 2 ill get a photo or 2 to show exactly what it look like but to replace these seals and stuff is this going to need a engine pull? or is this something fairly simple? i haven't found too much info on it for our bikes. Thanks guys.
ramcharger is offline  
Sponsored Links
Advertisement
 
Reply

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Similar Threads
Thread Thread Starter Forum Replies Last Post
HELP! Push rod stuck? tajaii Vulcan 900 0 03-09-2017 09:30 AM
Help, can't get push rod in all the way wescook General Vulcan Talk 1 07-03-2015 10:31 PM
Slave cylinder leak, push rod oil seal - Question Old-Man Engine Work 2 09-26-2014 09:44 PM
Clutch push rod seal brian518 Vulcan 1500 2 10-06-2013 09:59 AM
Clutch push rod gasket is leaking AGAIN! Windburn Bill Vulcan 1600 5 03-13-2012 08:51 PM

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome