New to this forum. - Kawasaki Vulcan Forum : Vulcan Forums
» Insurance
» Sponsors
Go Back   Kawasaki Vulcan Forum : Vulcan Forums > Motorcycle Models > Vulcan 1500

Reply
 
Thread Tools Display Modes
Old 01-03-2013, 01:29 PM   #1
FreedomFighter1983
Junior Member
 
Join Date: Jan 2013
Posts: 6
Default New to this forum.

*Howdy.How is everyone doing? I am from south of Houston and I just found this forum and very thankful I did. It is very informative. Although I can't find a solution to one particular problem I am having. I know this is the introduction page but I am hoping someone can point me to the correct thread.*My 2002 Vulcan 1500c will not start. I replaced the battery about 3 months ago so I doubt that is the issue. What is happening is, in the morning I go to start it and it will continue to try to fire but all that happens is the starter will turn and cause the engine to turn but I get no spark most of the time. (changed spark plugs last month.) If I charge it it will fire and start up and not have a problem till the next morning when I have to do it all over again. Tends to happen when it is cooler than 50 degrees out. It is almost like something is draining my battery when the key is not even in it.*If anyone has any ideas or thoughts please let me know, our if you know where the thread is that can help me you would be a life saver.
FreedomFighter1983 is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 01-03-2013, 02:56 PM   #2
vulcanfun
Member
 
Join Date: Mar 2012
Posts: 77
Default re: new to this forum

Welcome to this forum Freedom Fighter it`s always good to have new riders on board especially with 1500`s. If you have a service manual (factory or not) you should first be sure your battery has about 13 volts, more is better, then check the charging system with a good meter. In my case I had to replace the stator once and my starting issues were over( for that case anyway). If you check your battery voltage, before you try to start it, and find that it is 12.8v or less then you probably don`t have enough charge for a start. If you charge your battery and it gets to at least 13.5v then the battery is probably ok. New batteries usually have 14.2v and 13.8 is what I call healthy less is worse.

hoping your not confused by this post,
vulcanfun
vulcanfun is offline   Reply With Quote
Old 01-03-2013, 04:13 PM   #3
FreedomFighter1983
Junior Member
 
Join Date: Jan 2013
Posts: 6
Default

I am getting the clymers manual in the mail tomorrow or the next day. Tomorrow I will be changing the oil and air filter.

I have had it charging all day and once I get back home I will attempt to crank it up. More than likely it will fire and run all night till I park it when I am done. Tomorrow the battery will not have enough power to crank it up. I could simply leave it charging when I am not riding but I think there is a deeper problem that I need to resolve.
I will test the battery when I start it tonightand again in the morning to see the difference.


Sent from my SPH-D710BST using Motorcycle.com Free App
FreedomFighter1983 is offline   Reply With Quote
Old 01-03-2013, 07:28 PM   #4
Steammaker
Top Contributor
 
Steammaker's Avatar
 
Join Date: Sep 2012
Location: SW Ohio
Posts: 673
Default

Welcome to this forum Freedom Fighter it`s always good to have new riders on board. Hope you get your starting issues resolved...
__________________
'03 MEANSTREAK
Steammaker is offline   Reply With Quote
Old 01-03-2013, 09:54 PM   #5
Romans5.8
Super Moderator
 
Romans5.8's Avatar
 
Join Date: Aug 2011
Location: Missouri
Posts: 5,804
Garage
Default

Welcome!

The New Member Introduction section is one way we deal with spammers, it's a necessary evil. But, it's also a fantastic way for us to get to know you!

If you post your question down in the Vulcan 1500 forum you might get more help. Good luck!
__________________
"8 But God demonstrates his own love for us in this: While we were still sinners, Christ died for us."

Romans 5:8 (NIV)

2006 Vulcan 900 Classic LT "Couch-a-Saki/Mini-Bagger"

2011 Honda Shadow Aero 750 (Wife's)
Romans5.8 is offline   Reply With Quote
Old 01-03-2013, 10:30 PM   #6
sfair
Top Contributor
 
Join Date: Apr 2009
Posts: 6,489
Default

You will need a meter and know how to use it. If not, we can help you out there too.

Post back.
sfair is offline   Reply With Quote
Old 01-04-2013, 04:16 AM   #7
Kojack
Member
 
Join Date: Aug 2012
Posts: 69
Default

It still could be your battery. Have it load tested. However, go through the electrical system. see if there are any cracks in your plug wires or wiring in general. Then try things like your ignition switches. electrical gremlins are little buggers to get out.
Kojack is offline   Reply With Quote
Old 01-04-2013, 04:42 AM   #8
Bear2123
Top Contributor
 
Bear2123's Avatar
 
Join Date: Oct 2011
Location: SW Chicago suburbs
Posts: 3,969
Default

Hello & Welcome! Yup, lot's of great help here. Be patient, you'll be allowed to post soon.
Bear2123 is offline   Reply With Quote
Old 01-04-2013, 12:14 PM   #9
The Heater
Lifetime Premium
 
The Heater's Avatar
 
Join Date: Apr 2010
Location: Auburn, WA
Posts: 397
Default

Hi, Freedom Fighter, and welcome!! I love the city of Houston, I have a close cousin and her family there, love to go visit. Texas is a cool place.

If the battery is new, it is producing enough voltage and amperage to start your vehicle. If you get a result by a fresh top up charge, I would look at the starter motor. If it is worn it will draw more current. If it draws too much current, what happens is the battery must produce more voltage (to provide current demand) to cause the armature to rotate at a sufficiently high rpm to turn the motor fast enough to start. The voltage output of a battery drops as it discharges, so the heavy draw from any starter motor is going to drain it fast, and if it already is taking too much current, you got a problem even with a new battery.

That's just one place to look, I don't guarantee that solves your problem, but if you can get the starter out and take it to an auto electric rebuilder, they can bench test it for you. If you don't want to get it out, you may want to have a bike shop test it on the bike for how much current it is drawing.

Last edited by The Heater; 01-04-2013 at 12:16 PM.
The Heater is offline   Reply With Quote
Old 01-05-2013, 02:28 PM   #10
sfair
Top Contributor
 
Join Date: Apr 2009
Posts: 6,489
Default

Kawasaki starters give little to no trouble, so they are generally way, way down on the list of usual suspects.
sfair is offline   Reply With Quote
Sponsored Links
Advertisement
 
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Powered by vBadvanced CMPS v3.2.2

All times are GMT -5. The time now is 09:44 PM.


Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Garage Plus vBulletin Plugins by Drive Thru Online, Inc.
Motorcycle News, Videos and Reviews
Honda Grom Forum Harley Davidson Forum Honda 600RR Kawasaki Forum Yamaha R6 Forum Yamaha FZ-09 Forum
1199 Panigale Forum Roadglide Forum Honda CBR1000 Forum Vulcan Forum Yamaha R1 Forum Yamaha R3 Forum
Ducati Monster Forum Harley Forums Honda CBR250R Forum ZX10R Forum Star Raider Forum Yamaha Viking Forum
Suzuki GSXR Forum V-Rod Forums Honda Shadow Forum Kawasaki Motorcycle Forum Star Warrior Forum KTM Duke 390 Forum
SV650 Forum BMW S1000RR Forum Honda Fury Forum Kawasaki Versys Forum Drag Racing Forum Ducati 899 Panigale Forum
Suzuki V-Strom BMW K1600 Triumph Forum Victory Forums Sportbikes BMW NineT Forum
Volusia Forum BMW F800 Forum Triumph 675 Forum MV Agusta Forum HD Street Forum Suzuki GW250 Forum
Yamaha Motorcycles Victory Gunner Forum Honda Vultus Forum