from lava wrap instructions
6. It is important to start on side closest to exhaust port (closest to engine), wrapping down the system
towards the exhaust tip.
7. Make an initial wrap around the pipe and secure end with Thermal-Tie™ (Figure 4) or hose clamp.
8. After securing end, continue to wrap around pipe, using ¼” overlap with each pass (Figure 2) and
keeping tension on the exhaust wrap.
'11 Red Vaquero o#\o 87HP 106lb ft
Thunder MFG air Kit, V&H slip ons, PCV with a dyno map, pin stripe, Avon grips with Ray's mod, KQR sissy bar,TLC bag liners, 1/8" stereo adapter with Bluetooth Receiver (BlueBridge), power outlet, Marvella's cup holder, 205/60 General Altimax HP - darkside