2011 exhuasts

bearwhiz · 11-03-2012, 06:53 PM

I debaffled my 2006 Vulcan Nomad 1600 using the hole saw and round piece of wood. But how do I debaffle my wife's 2011 Vulcan 900 with the angle flat piece at the end of the exhaust? Help!!!

KenDawg · 11-03-2012, 10:30 PM

1. Drill out the rivets
2. Peel metal back with pliers/vice grips

3. I cut the baffle off a bit with a saw

4. Stage 1-12" extension with 3/4 " hole saw-Drill out plate near back of baffle
http://www.myspace.com/video/mark/vu...ase-1/57843028
5. Stage 2 (personal favorite) drill 4-8 3/8 inch holes in baffle plate

http://www.youtube.com/watch?v=H2L0IrNTqkU

6. Stage 3- Completely cut around baffle, cut plate off with 3" hole saw, work baffle untill it pops loose

Good luck!

bearwhiz · 11-07-2012, 08:27 PM

I'm done. Sounds great.

KenDawg · 11-07-2012, 09:45 PM

Happy you like it.

Romans5.8 · 11-08-2012, 01:02 PM

One of the coolest free mods you can do! Doesn't sound QUITE as nice as aftermarket pipes but it's not nearly as loud either. I'm partial to a full debaffle myself. I started mine up in stages and found that the 'full debaffle' was only marginally louder than the 'stages' but much, much deeper and rumblier.