I bought a used Vulcan and the previous owner installed some LEDs on the rear. They are no longer working. I traced the wires back under the seat and they are tied into the wiring harness. One is hooked into a blue wire and the other into a black/yellow wire. Are these turn signals?
The lights aren't working so I'm going to remove them. What is the best way to remove the taps without damaging the harness? Should I do anything to the wires after removing the taps?
they should snap open and pull off. Now get some rubber cement and coat the wires, where the cuts are To seal them
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Kawasaki Vulcan Forum
712.7K posts
67.9K members
Since 2008
A forum community dedicated to Kawasaki Vulcan motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, Vulcan 1500, Vulcan 2000, Vulcan 500, Vulcan 1600, Vulcan 900 and all other Vulcan motorcycles.